A new low cost method to remove toxic from Waste Water- A low-cost method has been developed by INST researchers to remove toxic Chromium from wastewater of industries such as leather tanning and electroplating by using “sunlight” as catalyst in combination with microfluidic technology.
According to WHO reports toxicity of hexavalent chromium is a serious concern and the tolerable concentrations of hexavalent and trivalent chromium in drinking water are limited to 0.05 mg/L and 5 mg/L. Thus, it becomes imperative to reduce this hexavalent form of chromium to the trivalent form.
Check University of Allahabad PhD admission
Several chemical and physiochemical methods, such as ion exchange, adsorption, and bacterial and chemical reduction, have been employed for the removal of Cr(VI). Most of these techniques are costly, with low removal efficiencies of Cr(VI).
Dr. Bhanu Prakash’s research group from Institute of Nano Science and Technology (INST), Mohali, an autonomous institute of Department of Science and Technology has developed a new technique of removing toxic Cr(VI) ions by utilizing sunlight for the catalytic process in combination with microfluidic technology for the conversion of the toxic hexavalent form of chromium to a less toxic trivalent form. They used a process called continuous flow photoreduction and validated this process in wastewater using TiO2 nanoparticles with the help of a smartphone based colorimetric technique.
A new low cost method to remove toxic from Waste Water
Besides, the cost effectiveness of the process and the usage of renewable energy, with the microfluidics route, the reduction efficiency can also be tailored by fine-tuning the flow rate of the organic pollutant, reactor dimension, and architecture, precisely. One of the most advantageous features of using microreactors is the reusability of the photocatalyst without any recovery agents or cumbersome processes.
Various microfluidic parameters such as reactor design, flow rate and channel length along with different catalyst phases were fine-tuned to bring about superior degradation efficiency. A superior degradation efficiency of 95 % was attained by utilizing a serpentine microreactor coated with a photocatalyst in the pure anatase phase at a flowrate of 50 µl/min.
The researchers started the process with the fabrication of microfluidic reactors and the synthesis of nanocatalysts. Next, the nanocatalyst was immobilized onto the microreactor bed and flow experiments were performed. The extent of conversion was monitored using a change in absorbance via UV-Vis spectroscopy. This was followed by evaluating the reactor performance on basics of long-term stability of microreactor and photocatalyst with respect to the number of cycles or volume processed.
This work published in Chemical Engineering Journal holds potential in industrial translation by increasing the throughput of the approach. This is possible by setting up microfluidic reactors in a parallel approach (arrays) or by microtexturing of the bulk reactor surface to increase the efficacy of the process after repetitive use
Check our Facebook